win 10 disable automute when headphones plugged in

WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN MANUAL
WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN PC
WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN WINDOWS

At the risk of belaboring that point, did you check all of the tabs?įor example, my USB audio device (a literally $10 jobbie I got from Newegg) doesn’t do any kind of fancy auto-switching, but it does have a bunch of different output configurations because it’s one of those units with a combo analog/digital headphone jack, where there’s an LED at the bottom of the port so you can stick a specially-shaped optical cable in there and use SP/DIF. (Though I guess that was more of a danger when it was in active development, now it seems like it’s in a holding beat me to the pavucontrol suggestion, as that would’ve been my first instinct as well. It may be possible to do it that way, but it’s likely that it’ll mess something up for PulseAudio, or that PulseAudio will mess you up at some point in the future. I highly doubt that ALSA is where you want to fiddle with this. I think it should be possible to separate outputs somehow for alsa but I haven’t found a way to do it.

Kernel modules: snd_hda_intel, snd_soc_skl, sof_pci_dev

Lspci: Audio device: Intel Corporation Cannon Lake PCH cAVS (rev 10)

The same behavior on my work computer with Realtek ® ALC887 8-channel high definition audio CODEC*Īplay - PCH, device 0: ALC887-VD Analog Whereas lspci shows Audio device: Intel Corporation 7 Series/C216 Chipset Family High Definition Audio Controller (rev 04)

WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN MANUAL

Manual says it’s Realtek ® ALC892 8-channel High Definition Audio CODEC.Īplay -l shows it as card 0: PCH, device 0: ALC892 Analog I use desktop computer with Asus motherboard’s integrated audio. I do use a rather crude workaround for this with alsamixer – but it’s rather clumsy and switches between outputting sound to both devices simultaneously or headphones only – not an elegant solution. I’ve searched for solution for some time but couldn’t find anything good. I think I’ve seen them as separate devices on older (not recent) versions of Fedora as well but I can be mistaken here.

WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN WINDOWS

I have to say that Windows does show speakers and headphones as separate output devices and allows switching between them easily – so I’m quite sure the same can be achieved in Linux.

WIN 10 DISABLE AUTOMUTE WHEN HEADPHONES PLUGGED IN PC

You need not restart your PC or anything else.I know that sound output switching works ok when I physically remove/connect my headphones, but is there a way to achieve the same without unlugging anything? This will change the input device behavior permanently and instantly.

Change the Auto-Mute value from Disabled to Enabled using Up/Down arrow keys:.

Using arrow keys, scroll the app's interface to the right until you see the trackbar called 'Auto-Mute'.

This will start the alsamixer app in the playback mode.

Type the following command: alsamixer -V playback.

The default XFCE terminal is a good choice. without pulseaudio but with ALSA, you need to do the following to resolve the headphones issue: Here is a simple solution for this issue. Before installing XFCE, this worked like a charm. When I plugged in headphones, the speakers were not muted. I noticed a weird behavior related to the sound system. Some time ago, I switched from Fluxbox to XFCE in my primary operating system, Arch Linux. RECOMMENDED: Click here to fix Windows issues and optimize system performance

Win 10 disable automute when headphones plugged in